How to Adjust Look Pivot Bindings (Step-by-Step Guide)
In the video below, We'll walk you through how to properly adjust your Look Pivot bindings when you’re in a pinch. While we always recommend having a certified ski technician handle any binding adjustments, this guide helps you understand how the process works and what to look for if you need to make tweaks on the hill.
Step 1: Check the Binding Arms
The Look Pivot's bindings rely on forward pressure, no additional AFD adjustments. Start by checking the binding arms. They can sometimes sit unevenly—look for the small marker dashes on the lower part of the binding arm.
Pop the heel piece up without a boot being engaged, grab a Phillips head screwdriver, and adjust the arms until they’re even on both sides. This ensures consistent contact and safe retention.
Step 2: Set the Forward Pressure
Next, focus on the forward pressure indicator—that small white tab with hash marks behind the heel. When your boot is clicked into the binding, that tab should sit flush between the two lines.
If it’s too far forward or back, your forward pressure is off.
-
Too far forward = not enough pressure
-
Too far back = too much pressure
- Perfect = end of white tab lines up directly with the hash marks.
Remove your boot, pop the heel tab, and tighten or loosen the binding arms slightly until the tab sits perfectly in the middle.
Clockwise will shorten the length of the arm and increase forward pressure. (Do this if the white tab is too far forward or if the tab doesn't reach the hash marks).
Counter clockwise will increase the length of the arm and decrease forward pressure. (Do this is the white tab is too far back or if the white tab has move past the hash marks).
Step 3: Adjust the DIN Settings
Your DIN setting determines how easily your binding releases during a fall. It’s based on your:
-
Height
-
Weight
-
Age
-
Boot sole length
-
Skier type (beginner, intermediate, or expert)
To adjust the heel DIN, lift the tab to expose the flathead screw and make small turns—a little goes a long way. For the toe DIN, use a flathead or Phillips screwdriver to match the toe value to the heel.
⚠️ Safety Note: DIN settings should always be set and verified by a certified technician. Incorrect values can lead to premature release or injury.
Final Check
When everything feels even and responsive, click in, twist, and test. You should feel solid engagement and consistent release tension between toe and heel.
That’s it—your Look Pivot bindings are adjusted and ready to ride.
Shop: Ski Bindings
Shop: Look Pivot 2.0 13
Shop: Look Pivot 2.0 15
Shop: Look Pivot 2.0 18
Still Unsure? Let the Pros Handle It
Even though it’s handy to know how these adjustments work, your best bet is to take your skis to a certified shop technician for any final tuning or calibration. If you’re near Boston, swing by The Ski Monster—our experts will get you set up safely and ready for your next run.
Related:
How to Adjust Marker Griffon Bindings